Quick Start Guide

QUICK START GUIDE

Thank you for choosing Omnilux Contour™! Follow these easy steps to start your journey towards fresher, brighter-looking skin.

  1. Charge Omnilux Contour™
    Insert micro USB cable into the Controller, insert the opposite USB end into the appropriate power supply plug-type for your area. Plug into wall outlet.
    Lights on Controller will blink while charging (All 3 lights will be illuminated when Controller is fully charged (approx. 4 – 5 hrs). Note: the Face & Neck & Decollete device should NOT be plugged in while the controller is charging. The device will not power on if plugged in while charging and this can cause damage to the unit over time.

  2. Prepare Skin
    Remove make-up, and cleanse and/or exfoliate skin prior to treatment. Apply Omnilux Contour Hydrogel Mask if applicable.

  3. Treatment
    Secure Omnilux Contour to applicable treatment area using Velcro straps. Press and hold the button on Controller for 1 – 2 seconds until device illuminates. Omnilux Contour will switch off automatically at the end of the 10 minute treatment.

  4. Post Treatment
    Massage any remaining Hydrogel into the skin (if applicable) and finish off with favorite moisturizer and sunscreen..

  5. Cleaning
    Clean Omnilux Contour with a water-based wipe or a damp clean cloth. Do Not clean while device is in charging mode.

  6. Repeat
    Repeat treatment 3 – 5 times per week for 4 weeks for best results, and thereafter as desired to maintain results.

NOTE: Refer to the Omnilux Contour User Guide that comes with your device for complete instructions for use, warnings, precautions and contraindications.